Command Line Interface Guide

omreport storage Commands 203
Table 7-2. omreport Physical Disk Commands
Required Command
Levels (1, 2, 3) and name=
value pair
Optional name=value pairs Use
omreport storage
pdisk
controller=id
where id is the controller number.
For example: controller=0
Displays all physical disks
attached to the specified
controller.
NOTE: If a physical disk
was replaced by another
disk as part of the replace
member operation, the
state of the physical disk is
displayed as
Replacing.
vdisk=id
where id is the virtual disk number.
For example:
vdisk=1
Displays all physical disks
included in the specified
virtual disk on the
controller.
cachecade=id
where id is the cachecade number.
For example:
cachecade=1
Displays all physical disks
included in the specified
cachecade on the
controller.
connector=id
where id is the connector number.
For example: connector=1
Displays all physical disks
attached to the specified
connector on the
controller.
pdisk=connectorID : targetID |
connectorID : enclosureID :
slotID
where connectorID:targetID is the
connector number and the physical
disk number and
connectorID:enclosureID:slotID is
the connector number, enclosure
number, and slot number.
For example: pdisk=0:2 or pdisk=
0:1:2
Displays the specified
physical disk on the
specified connector on the
controller.