Command Line Interface Guide

20 Introduction
The omconfig command writes values that you assign to an object's
properties. You can specify values for warning thresholds on components or
prescribe action that the system must perform when a certain warning or
failure event occurs. You can also use the omconfig command to assign
specific values to the system's asset information parameters, such as the
purchase price of the system, the system's asset tag, or the system's location.
The omhelp command displays short text help for CLI commands.
The shorthand equivalent of omhelp is the command for which you want
help followed by -?. For example, to display help for the omreport command,
type one of the following commands:
omhelp omreport
omreport -?
The omreport command displays reports of the management information of
the system.
NOTE: For an overall summary of the CLI commands, type omhelp.
Table 1-1 lists the primary CLI commands used by Server Administrator.
This guide contains a section for each primary command.
NOTE: The omupdate commands are no longer supported in Server Administrator
and are replaced by Dell Update Package or the Server Update Utility commands. To
update the different components, download the Dell Update Package and run the
<package name> /s [/f]command. For more information on the
Table 1-1. CLI Commands and Sections in This Guide
Primary CLI
Command
Section Title Related Sections
omconfig "omconfig: Managing Components
Using the Instrumentation Service"
on page 91
"omconfig system or
servermodule assetinfo: Editing
Cost of Ownership Values" on
page 177
omhelp "Using the omhelp Command" on
page 27
omreport "omreport: Viewing System Status
Using the Instrumentation Service"
on page 31