Command Line Interface Guide

omconfig system or servermodule assetinfo: Editing Cost of Ownership Values 181
Example Commands for Adding Depreciation Information
To provide a value for a depreciation parameter, type a command of the form:
omconfig system assetinfo info=depreciation <name=value pair 2> or
omconfig servermodule assetinfo info=depreciation <name=value pair 2>.
For example, type:
omconfig system assetinfo info=depreciation
method=straightline
or
omconfig servermodule assetinfo info=depreciation
method=straightline
The following message is displayed:
Asset information set successfully.
You can type more than one omconfig system assetinfo or omconfig
servermodule assetinfo command at the same time, as long as all the
parameters for name=value pair 2 belong to name=value pair 1. For an
example, see "Example Commands for Adding Acquisition Information" on
page 179.
Adding Extended Warranty Information
Use the omconfig system extwarranty or omconfig servermodule extwarranty
command to assign values for extended warranty information. A warranty is a
contract between the manufacturer or dealer and the purchaser of a system.
The warranty identifies the components that are covered for repair or
replacement for a specified length of time or usage. The extended warranty
comes into force after the original warranty expires. For details on how to edit
warranty values, see "Adding Warranty Information" on page 193.