Command Line Interface Guide

168 omconfig: Managing Components Using the Instrumentation Service
omconfig system events or omconfig servermodule events
Use the omconfig system events or omconfig servermodule events command
to enable and disable SNMP traps for the components on your system.
NOTE: Not all event types are present on the system.
There are four parameters in the name=value pair component of the
omconfig system events command:
•Source
•Type
• Severity
•Index
event=
removableflashmediafail
Sets actions that Server Administrator performs when
a removable flash media fails.
event=tempfail Sets action or enables or disables alert generation
when a temperature probe detects that the
temperature is either too high or low for proper
operation.
event=voltfail Sets action or enables or disables alert generation
when a voltage probe detects that the voltage is too
low for proper operation.
event=intdualsdcardcritical Sets actions that Server Administrator performs when
an internal dual SD card critical event occurs.
event=intdualsdcardwarn Sets actions that Server Administrator performs when
an internal dual SD card warning is displayed.
event=intdualsdcardabsent Sets actions that Server Administrator performs when
an internal dual SD card is not available.
event=
intdualsdcardredunlost
Sets actions that Server Administrator performs when
the redundancy of an internal dual SD card is lost.
event=watchdogasr Enables or disables alert generation configured by the
ASR when the system has hung or is not responding.
Table 4-26. Parameters of omconfig system platformevents
(continued)
Event Name Description