Command Line Interface Guide

164 omconfig: Managing Components Using the Instrumentation Service
omconfig system pedestinations or omconfig servermodule
pedestinations
Use the omconfig system pedestinations or omconfig servermodule
pedestinations command to set IP addresses for alert destinations.
Table 4-24 lists the valid parameters for the command.
NOTE: You can either specify the index and IP address as parameters together or
you can set the community string alone as a parameter.
NOTE: Index 1 to 4 accepts an IPv4 address and index 5 to 8 accepts an IPv6
address.
omconfig system platformevents or omconfig servermodule
platformevents
Use the omconfig system platformevents or omconfig servermodule
platformevents command to configure shutdown action, if any, taken for a
specific platform event. You can also enable or disable platform event filter
alert generation.
CAUTION: If you set a platform event shutdown action to anything other than
none or power reduction , the system is forcefully shutdown when the specified
event occurs. This shutdown is initiated by firmware and is carried out without
first shutting down the operating system or any of the applications running on
your system.
Table 4-24. Parameters of omconfig system pedestinations or omconfig servermodule
pedestinations
name=Value Pair Description
destenable=true |
false
true: Enables an individual platform event filter destination
after a valid IP address has been set.
false: Disables an individual platform event filter.
index=number Sets the index for the destination.
ipaddress=ipv4 |
ipv6 address
Sets the IP address for the destination.
communitystr=text Sets the text string that acts as a password and is used to
authenticate SNMP messages sent between the BMC and the
destination management station.