Command Line Interface Guide

omconfig: Managing Components Using the Instrumentation Service 139
failovernw=none | lom1 |
lom2 | lom3 | lom4 | all
none: Configures the failover network to
none.
lom 1:Configures the failover network to
lom 1.
lom 2: Configures the failover network
to lom 2.
lom 3: Configures the failover network
to lom 3.
lom 4: Configures the failover network
to lom 4.
all: Configures the failover network to all
loms.
NOTE: The failovernw option is supported
on PowerEdge yx2x systems onwards.
Configure both primarynw and failovernw
to set the nicselection. The primarynw and
failovernw options cannot have the same
value.
NOTE: Failovernw requires license to
configure the ports. If the appropriate
license is not installed or has expired, the
system displays an error message. For
more information, see
The Dell Licensing
Management Guide at
dell.com/support/manuals.
ipaddress=IP ip: Sets the IP address if you have
selected static as the IP address source
for the BMC LAN interface.
subnet=Subnet Sets a subnet mask if you have selected
static as the IP address source for the
BMC LAN interface.
gateway=Gateway Gateway: Sets a gateway address if you
have selected static as the IP address
source for the BMC LAN interface.
Table 4-12. Parameters of omconfig chassis remoteaccess or omconfig mainsystem
remoteaccess
(continued)
name=value pair 1
config=
name=value pair 2 Description