Command Line Interface Guide

138 omconfig: Managing Components Using the Instrumentation Service
nicselection=
sharedwithfailoveronall |
nic1 |teamednic1nic2 |
dracnic
sharedwithfailoveronall: Configures the
new NIC selection option.
nic1: Enables NIC 1.
teamednic1nic2: Enables NIC teaming
functionality.
dracnic: Enables DRAC NIC if DRAC 5
is installed.
NOTE: The nicselection option is
supported only on PowerEdge x9xx to yx1x
systems. From PowerEdge yx2x systems
onwards, primarynw and failovernw
replace nicselection.
primarynw=dedicated |
lom1 | lom2 | lom3 |
lom4
dedicated: Configures dedicated port as
primary network for remote access.
NOTE: This option requires license to
configure primarynw as dedicated. If the
appropriate license is not installed or has
expired, the system displays an error
message. For more information, see
The
Dell Licensing Management Guide at
dell.com/support/manuals.
lom 1: Configures lom1 port as the
primary network for remote access.
lom 2: Configures lom2 port as the
primary network for remote access.
lom 3: Configures lom3 port as the
primary network for remote access.
lom 4: Configures lom4 port as the
primary network for remote access.
NOTE: The primarynw option is supported
from PowerEdge yx2x systems onwards. If
the primarynw is set to dedicated, then set
failovernw to none.
Table 4-12. Parameters of omconfig chassis remoteaccess or omconfig mainsystem
remoteaccess
(continued)
name=value pair 1
config=
name=value pair 2 Description