Command Line Interface Guide

omconfig: Managing Components Using the Instrumentation Service 137
The output of the omconfig chassis remoteaccess or omconfig mainsystem
remoteaccess command lists each of the available configurations. The
following table lists the valid parameters:
Table 4-12. Parameters of omconfig chassis remoteaccess or omconfig mainsystem
remoteaccess
name=value pair 1
config=
name=value pair 2 Description
config=
additional
ipv4=enable | disable enable: IPv4 stack to load on iDRAC.
disable: IPv4 stack to flush on iDRAC.
ipv6=enable | disable enable: Enables IPv6 stack to load on
iDRAC.
disable: Disables IPv6 stack to unload on
iDRAC.
NOTE: This option requires license to
enable or disable ipv6. If the appropriate
license is not installed or has expired, the
system displays an error message. For
more information, see
The Dell License
Manager
at dell.com/support/manuals.
config=advsol characcuminterval=
number
number: Sets the character accumulate
interval in 5 millisecond intervals.
charsendthreshold=
number
number: Sets the number of characters.
BMC automatically sends a serial over
LAN data packet that contains the
number of characters as soon as this
number of characters (or greater) has
been accepted from the baseboard serial
controller into the BMC.
enableipmi= true | false true: Enables IPMI over LAN.
false: Disables IPMI over LAN.
enablenic=true | false true: Enables DRAC NIC.
false: Disables DRAC NIC
NOTE: The enablenic option is supported
only on PowerEdge
x 9 xx systems that
have DRAC 5 installed.