Command Line Interface Guide

126 omconfig: Managing Components Using the Instrumentation Service
When you issue the command and the system sets the values you specify, the
following message is displayed:
Fan probe warning threshold(s) set successfully.
NOTE: You cannot set the minimum and maximum warning thresholds for the fan
probe on PowerEdge x8xx and x 9 xx systems.
omconfig chassis frontpanel or omconfig mainsystem frontpanel
Use the omconfig chassis frontpanel or omconfig mainsystem frontpanel
command to:
• configure the power button and the Nonmasking Interrupt (NMI) button
• configure the LCD to display:
– No information
– Custom information
– Default system information
– Service tag, system name
– Remote access MAC addresses
– System power
– Remote access IP address
– Ambient temperature of the system
– Remote access IPv4 address
– Remote access IPv6 address
•Specify and configure the LCD line number
• View the encryption state report of the LCD
• Configure LCD to indicate an active remote session when the Kernel-
based Virtual Machine (KVM) is available
NOTE: You can configure the Power and NMI buttons only if they are present on
the system.