Command Line Interface Guide

omconfig: Managing Components Using the Instrumentation Service 115
Table 4-4 displays the BIOS setup attributes supported on PowerEdge yx2x
systems. On PowerEdge yx2x systems, the attributes are grouped. Based on
the hardware configuration, the possible attributes may vary in a specific
group. The omconfig chassis biossetup command does not display the read-
only attributes.
NOTE: If you have configured the setup password, then, always set the same when
you configure any BIOS settings.
Table 4-4. BIOS Setup Settings on PowerEdge yx2x Systems
Group name=value pair 1
attribute=
name=value pair 2
setting=
BIOS Boot Settings attribute=BootSeq sequence=aliasname1,
aliasname2,..... aliasnameN
attribute=HddSeq sequence=aliasname1,
aliasname2,..... aliasnameN
Boot Settings attribute=BootMode setting=Bios | Uefi
attribute=BootSeqRetry setting=Enabled | Disabled
Embedded Server
Management
attribute=FrontLcd setting=None | UserDefined |
ModelNum | Advanced
attribute=UserLcdStr setting=<string>
Integrated Devices attribute=EmbVideo setting=Enabled | Disabled
attribute=
IntegratedNetwork1
setting=Enabled | DisabledOs
attribute=
IntegratedNetwork2
setting=Enabled | DisabledOs
attribute=IntegratedRaid setting=Enabled | Disabled
attribute=IntegratedSas setting=Enabled | Disabled
attribute=InternalSdCard setting=On | Off
attribute=InternalSdCard
Redundancy
setting=Mirror | Disabled
attribute=InternalUsb setting=On | Off
attribute=InternalUsb1 setting=On | Off