Command Line Interface Guide

110 omconfig: Managing Components Using the Instrumentation Service
attribute=
numlock
setting=on | off on: Uses the keypad as number keys.
off: Uses the keypad as arrow keys.
attribute=numa setting=enabled |
disabled
enabled: Enables Node Interleaving.
disabled: Disables Node Interleaving.
attribute=
ppaddress
setting=off | lpt1 |
lpt2 | lpt3
off: Disables the parallel port address.
lpt1: Locates the device on LPT1.
lpt2: Locates the device on LPT2.
lpt3: Locates the device on LPT3.
attribute=
ppmode
setting=at | ps2 | ecp
| epp
at: Sets the parallel port mode to AT.
ps2: Sets the parallel port mode to PS/2.
ecp: Sets the parallel port mode to ECP
(extended capabilities port).
epp: Sets the parallel port mode to EPP
(enhanced parallel port).
attribute=
primaryscsi
setting=on | off
force=true
CAUTION: If you modify the setting for
primary scsi , romb , romba , or rombb , the
system becomes inoperable until you
reinstall the operating system.
on: Enables the primary SCSI.
off: Disables the primary SCSI.
force=true: Verification of
setting change.
Table 4-3. BIOS Setup Settings on Systems Prior to PowerEdge
yx2x Systems
(continued)
name=value pair 1
attribute=
name=value pair 2
setting=
Description