Owner's Manual

– SNMP Encryption Password: Maximum length is 255 characters. When the SNMP
Authentication Password is empty, the SNMP Encryption Password is also empty.
You can create multiple protocol profiles for each protocol.
4. Click Finish, or click Cancel to discard your entries and return to the Define IP Range screen.
5. Select your newly-added protocol and any others you require.
6. Click Back to return to the IP Range screen, click Next to continue, or click Cancel to discard your
discovery job.
5. In the Schedule Job screen, determine when you want your discovery job to run. You can choose between running
the job now, or scheduling the job to run at a future time.
6. Click Back to return to the Connection Protocol screen, click Next to continue, or click Cancel to discard your
discovery job.
7. On the Summary screen, review your discovery job selections, and then click Finish to discover supported devices
that are connected to the network within the parameters you have set for this discovery job.
8. After the discovery job completes, go to the Devices screen, and make sure the correct devices are listed.
Adding A New Device
The Add New Device wizard allows you to manually add a new device to the device list.
1. Click Devices in the left navigation pane.
2. Click Add/Create in the task menu.
3. Click the Add New Device option.
4. Enter the name of the device you want to add in the Device Name field.
5. From the Device Type drop-down menu, select a device type from the options offered: Server, Chassis, PDU, UPS,
or Unsupported.
Depending on your device type selection, expanded Protocol Information and Additional Device Information
sections appear.
6. Enter either a valid IP Address or a Hostname. This is optional for Unsupported device types.
7. If you selected Unsupported as the Device Type, enter the device model information.
NOTE: Protocol Information is not required for Unsupported device types.
NOTE: If you selected UPS or PDU as the device type, you must select a protocol below.
8. Enter the information requested for the device you want to add under Protocol Information.
9. Enter the information requested under Additional Information:
NOTE: The options available depend on the device type you selected.
– Size of Device: Select the device height: 1-10 rack unit.
– Device Description: Enter a description for the device.
– Faceplate Power: Enter the faceplate power value.
– Derated Power: Enter the derated power value.
10. Click Finish to add the device, or click Cancel to discard your changes.
The device is added.
50