Owner's Manual

Category Supported Platform Validated Model

• ServerTech Smart CDU, 0U

CS-24V1-C20M

UPS Dell

• Dell N313P Line interactive UPS

w/ web card H910P

• Dell Online Rack UPS 3750R OL

K804N

• Dell UPS, 2700/2300VA, 120V,

3U K802N

APC

• APC Online UPS w/ Web card

SURTD3000XLI

• APC Smart-UPS 3000VA RM

SUA3000RM2U

• Smart-UPS 5000VA RM

DL5000RMT5U

Eaton

• Eaton Line interactive UPS w/

Web card PW5130I1750-XL2U

Emerson

• Emerson Online UPS w/ Web

card GXT2-2700RT208

For unsupported devices:

• Power Center does not communicate with unsupported devices; therefore, connection protocol and credential

information is not necessary.

• Unsupported devices cannot be discovered, only added manually to the device list on the Devices page.

• Power Center adds the unsupported device to the group structure, but cannot manage it using the available

management functions.

You may need to enter the following power values when adding supported or unsupported devices:

• Faceplate Power: The maximum amount of power that a group/device can draw; this value should be listed on

the power supply specifications. The faceplate power rating is typically much higher than the actual power used

by the device.

• De-rated Power: The default maximum power value; if a power measurement cannot be completed, this value is

used.

NOTE: Faceplate power value is always greater than the de-rated power value.

Protocol Profile

Power Center server uses a protocol profile to communicate with devices. The protocol profile specifies a device’s

connection protocol and credential information. You will select a protocol profile when you discover a new device.

You can set up multiple protocol profiles for each protocol. Additionally, you can add a new profile, edit an existing

profile, or delete a profile.

Power Center supports the following connection protocol types, and includes several optional settings:

NOTE: Get the correct protocol type and credential information from your system administrator. The user name and

password for the IPMI/WS-MAN protocol must be the same as those used for the iDRAC/CMC Web console.