Owner's Manual

Power Details for a Different Time Window
Click the arrows < > to view the details for the previous/next sampling time, or click the double arrows << >> to view the
details for the previous/next page of results for the current time window. You can click Average, Maximum, or Minimum
to display the selected value.
Average: The average value from the previous time point to the current time point.
Maximum: The maximum value from the previous time point to the current time point.
Minimum: The minimum value from the previous time point to the current time point.
For example, you view power details in the 1H (1 hour) window and the maximum value at 15:00 shows 500W and the
time interval is 6 minutes. This value would represent that the maximum power consumption from 14:54 to 15:00 is 500W.
NOTE: It is common to see some instantaneous values exceed the Power Cap value in the Maximum line. Power
Center monitors this value and controls it to the normal power range with this happens. You only need to pay
attention when the Average power value exceeds the Power Cap value.
NOTE: You can set the time interval (the period from a time point to the next time point) in the Settings page. For
information on configuring the interval, see Monitoring Settings.
Power Details for Racks
For racks, you can click Power Consumption to display PDU power consumption for all rack PDUs.
You can also click Power Policies to change a power policy.
NOTE: The Power Policies button is only enabled if you have configured a power policy in the Policies page.
You can view the following power details of PDU devices. For more information on supported PDU devices, see System
Requirements.
PDU device information, including PDU name, model, and IP address.
PDU outlet information, including outlet number, power (W), voltage (V), amps (A), and the time of the
information recorded, following the format <YYYY-MM-DD HH:MM:SS>. The table lists the information for each
outlet and the total power consumption for all outlets.
NOTE: For PDU outlet information, Power Center only supports the Dell Managed Rack PDU 6605.
Viewing Energy Consumption
The Power Details page provides the following energy consumption information:
IT Equipment Energy — The total energy consumption and cost for all managed devices in the selected device/
group.
NOTE: Power Center can read the power consumption of a device when it as at S0 (On) state. For devices in S4/S5
state, Power Center uses a fixed value (30W) to calculate the power consumption.
Cooling Energy — The estimated energy consumption and cost needed to cool the selected device/group.
Cooling Energy = IT Equipment Energy * Cooling Multiplier
You can configure the cooling multiplier on the Settings page, in the Energy Consumption section.
65