Owner's Manual

The Filter window opens.
3. Do one of the following:
– Click IP Range, and enter the start and end IP address of devices.
– Click Date Range, and enter the start and end date of device discovery. Enter the dates manually following
the format YYYY-MM-DD, or select the dates from the calendar. Devices discovered from 00:00:00 of start
date to 00:00:00 of the next day after the end date are displayed. For example, if you enter the filtering
option 2011-01-01 as both start date and end date, all devices discovered between 00:00:00 of 2011-01-01
and 00:00:00 of 2011-01-02 are displayed.
– Click Protocol, and select the protocols used for communication. You can select multiple protocols.
– Click Status, and select device statuses. You can select multiple statuses.
– Click Device Type/Model, and select the device type or device model. the device model is the specific
model information of a device type, for example, PowerEdge M610. All the models that currently exist in the
Devices page are shown. If you selected both Device Type and Device Model, make sure the device type
matches the device model, otherwise no result is shown.
– Click Physical Group, and select a physical group where the device is located. You can select any level of
the physical group, including data center, room, aisle, rack and chassis.
– Click Faceplate/Derated Power, and enter a faceplate or de-rated power range of devices.
– Click Power Capability, and select the power capability of the device. You can select multiple power
capabilities.
4. Click Apply.
The Devices page displays the filtered devices.
Sorting Devices
By default, on the Devices page, the devices are listed by Name in alphabetical order (A-Z). To sort the list, click the Up
or Down symbol next to the field to list the devices in ascending or descending order. The symbol of the current sorting
field is displayed in orange.
54