Release Notes

What’s New

• Power Center supports up to 6000 managed devices in a data center.

• Thermal event based policy.

• Chained PDU support.

• Provision to exclude IP range during device discovery.

• Support for new platforms.

• Support for additional PDU models.

• Customize the home page of the application.

• Simplified group creation.

• 3 additional pre-defined templates to create, customize, run and export reports.

• Modified filters to customize the results based on distinctive needs and environment.

Fixes

Known Issues

Issue 1: On the Power Analysis page, the available power of a group is not displayed correctly when the

rack’s peak power exceeds its allocated power.

Description: When the peak power consumption in the rack exceeds the power capacity, the available

power capacity becomes a negative value. While calculating the available power capacity on the parent

group it should be reduced in the total available power capacity. But in current OMPC code, the available

power capacity is counted as 0.

Resolution: When the peak power exceeds power capacity, OMPC will sent out critical event to remind

the user about the abnormal case. The user has to increase the available power of the rack by editing the

rack properties.

Issue 2: Power/temperature history data of last one hour time period is not updated.

Description: In all 30 minutes time zones (UST +30min, +1.30, +2.30, +3.30, and so on), the last one

hour data cannot be updated. You have to wait till the second half of each hour to get the data. For

example, you may have to wait till +3.00 to get the updated information, as it is not possible at +2.30

time period.

Resolution: If you are in the 30 minute time zone, it is recommended to wait till the second half of an

hour to query the last one hour data.

Limitations

Issue 1: The power graph is blank while viewing the power (or temperature) history.