Setup Guide

– Health of the Dell Chassis I/O Module Status.
For more information on downloading and installing the supported Dell Remote RACADM utility, go
to “en.community.dell.com/techcenter/systems-management/w/wiki/3205.racadm-command-line-
interface-for-drac”
For SNMP:
The Net-SNMP Perl module version 6.0.1 or later is installed.
For WS-MAN:
OpenWSMAN and its Perl binding are installed.
Operating system requirements
• Red Hat Enterprise Linux (RHEL) version 7.2 (32-bit and 64-bit)
• Red Hat Enterprise Linux (RHEL) version 6.7 (64-bit)
System requirements for managed systems
A managed system is a supported Dell device that you are monitoring. The requirements for the managed
systems are as follows:
Table 2. Supported firmware versions for Dell servers
Dell Servers iDRAC Firmware Versions
Dell 12th generation of PowerEdge servers 2.30.30.30 and 2.21.21.21
Dell 13th generation of PowerEdge servers 2.30.30.30 and 2.21.21.21
Dell 13th generation of PowerEdge servers (R830) 2.35.35.35 and 2.30.30.30
Dell Datacenter Scalable Solutions (DSS 1500,
DSS 1510 and DSS 2500)
2.30.30.30
Table 3. Supported firmware versions for Dell chassis
Dell Chassis CMC Firmware Versions
Dell PowerEdge M1000e Chassis 5.1 and 5.0
Dell PowerEdge VRTX Chassis 2.1 and 2.0
Dell PowerEdge FX2/FX2s Chassis 1.3 and 1.2
Table 4. Supported firmware versions for Dell storage arrays
Dell Storage Arrays Firmware Versions
Dell Compellent Storage Arrays 6.6 and 6.5
Dell EqualLogic PS-Series Storage Arrays 8.0.4 and 7.1.7
Dell PowerVault MD 34/38 Series Storage Arrays 08.25.04.60 and 08.20.12.60
6