Release Notes

• View and monitor warranty information for all the supported Dell devices.

• Monitor SNMP alerts and events generated from the supported Dell devices.

• View Knowledge Base (KB) information of the following Dell devices corresponding to an SNMP alert

or event for faster troubleshooting:

– 12th and later generations of Dell PowerEdge servers

– Dell PowerEdge M1000e, Dell PowerEdge VRTX, and Dell PowerEdge FX2/FX2s chassis

– Dell EqualLogic PS-Series Storage Arrays

• Launch the following web consoles from Nagios XI to perform further troubleshooting, configuration,

or management activities:

– Integrated Dell Remote Access Controller (iDRAC) Web Console of Dell PowerEdge Servers

– Dell Chassis Management Controller (CMC) Console

– Dell EqualLogic Group Manager Console

– Dell Compellent Storage Manager Console

Fixes

Important Notes

To visit Dell TechCenter for accessing whitepapers, blogs, wiki-articles, videos, Product communities and

forums, see: http://en.community.dell.com/techcenter/systems-management/w/wiki/ 6277.dell-

openmanage-plug-in-for-nagios-xi.

Known Issues and resolutions

• Issue 1

Description: If a Dell Chassis is configured with only Internet Protocol Version 6 (IPv6) address and is

not using the HTTPS default port number (default 443) and was discovered using the Host Name, then

the users will not be able to access Chassis Management Controller (CMC) web interface from the

Nagios XI console.

Version affected: Dell OpenManage Plug-in Version 1.0 for Nagios XI.

Resolution: If the default HTTPS port number (port 443) was changed, type https://[<CMC IPv6

address>]:<port number> in the web browser, where <CMC IPv6 address> is the IPv6 address

for CMC and

<port number> is the HTTPS port number. Please note that you must enclose the IPv6

address in the parenthesis([]).

• Issue 2

Description: In "Dell Server Overall Health Status" service, Power Supply Roll up status would be

shown as UNKNOWN even if the actual Power supply Roll up status is OK after upgrading iDRAC

firmware to 2.30.30.30 or a higher version when Dell server is discovered using WS-MAN. The actual

status will be shown correctly once there is any change in the health status of the Power supply.

Version affected: Dell OpenManage Plug-in Version 1.0 for Nagios XI.