Users Guide

Table 2. Dell Device Discovery Utility options
Options Short Description Description
-h
help Use to view information about
options.
-H
host Use to input IP address or fully
qualified domain name (FQDN) of
the host device.
-S
subnet Use to input subnet with mask.
-F
file Use to input filename with
absolute path. The file must
contain a list of IP addresses or
FQDN of host devices separated
by a new line.
-P
protocol Option for SNMP or WS-MAN
protocol.
-c
configuration file Use to configure protocol
parameters. The default file
is .dell_device_comm_params
.cfg. For more information see
About Protocol Parameters.
-t
template Use to specify the services
template file with absolute path.
The default file is
dell_server_services_temp
late.cfg
-f
force Use to overwrite an existing host
configuration file.
-d
all services Use to monitor all the services. If
you run the utility without this
option, then the basic three
services are created. For more
information, see
Table 3. Default
services created based on
selected protocol.
Based on the options you selected during discovery, the following services are run:
• If you run perl dell_agent_free_server_discovery.pl without the -d option, then the
following services are created by default and displayed in the user interface under Services:
– Dell Server Information
– Dell Server Overall Health Status
– Dell Server Traps
• If you run perl dell_agent_free_server_discovery.pl with the -d option, depending on the
protocol you selected, the following services are created by default and are displayed in the user
interface under
Services:
9