Web Client Guide

342 Actions Portlet | Actions and Adaptive CLI
Adaptive CLI Editor
This editor creates new Adaptive CLIs When you click New, or Edit after, selecting an existing
command, the command editor screen opens. You can create
Configure Command s, External
Command
s, and Show Command s.
The editor screen has the following tabs (the ones that appear depend on the type of command you
are editing):
• General
• Attributes
•Scripts
NOTE:
The Adaptive CLI Manager logs into devices in enable mode by default. For most configuration
commands (and even some show commands), you must typically first set the device to its configuration
mode. For example: The first Adaptive CLI Manager command must be
config t (Juniper E-Series) or
edit (Juniper M/T series) to initiate the router's config/edit mode.
Tip
Dell OpenManage Network Manager validates entries. If saving fails, a red “X” appears next to required
omitted entries.
Click Save to preserve the Adaptive CLI you have configured. Clicking Close does not save your
configuration.