Users Guide
Detail Steps to Start OMNM Virtual Appliance | Installing Virtual Appliance
52 OMNM 6.5.3 Installation Guide
Starting the Virtual Machine
After you have completed the above steps, you can start the OpenManage Network Manager
(OMNM) application in the VM console.
NOTE:
Before you start the VM console, make sure that you make any needed VM setting modifications by right-
clicking the Image to get the menu of options.
1
Start the VM by clicking on its name and then selecting Power > Power On.
2
Open the VM Console.
3
Log in with the default credentials (synergy user).
U
sername: synergy
Password: synergyP@$$
The synergy user has passwordless sudo privileges.
Continue with
Completing the Initial VM Host Configuration
.
Completing the Initial VM Host Configuration
A user setup menu script simplifies VM initialization. Complete the initial VM host configuration
from the command line as follows.
1
Log in as the synergy user (synergy/synergyP@$$).
2
Enter the following command:
./setup
3
Select 1) VM Configuration Menu and follow the prompts.
If the setup is not successful, resolve any issues and then repeat step 3.
NOTE:
The VM initialization is designed to detect all available ethernet interfaces. Typically this is eth0 or ens32.
Make sure eth<zero> is entered when asked. ethO (oh) is not a valid Linux interface and interface
configuration will not be successful. If no interfaces are listed, do not proceed and do not make up an
interface name. Contact your VM administrator.
If a customized VM configuration is required to support alternate interfaces, DNS, or other
environments, contact your Linux and network administrator.
4
Reboot the VM.
5
Enter
./setup
and then select the Check Server Status option.
This continuously checks the server status until the servers start successfully. If startup is
successful, the following message is displayed.
===================================================
Application server status:---- appserver: ready
Web server Status:------------ synergy is running synergy is ready
Database server status:------- owaredb is running
===================================================
Once the VM setup is complete, continue with the configuration by
Starting the
Application
.