Users Guide
Monitoring Network Availability | Performance Monitoring
OMNM 6.5.3 User Guide 397
4
Notice that the Select your inventory columns panel displays the attributes associated with
the monitor targets. These attributes are the same for each monitor target entity type. This is
unlike the monitor data entity types, where the list of available attributes is different for each
monitor.
5
Select Available columns and click the right arrow to move them to Selected. In this case we
select Monitor Target, Equipment, Availability, Last Polled, Enabled, Device Management
State.
6
Arrange the columns and fonts as you like in the Layout tab.
7
Save the template.
8
Right-click, and select New in the Reports portlet.
9
Enter a Name and Title for the report.
10
Notice that since this is the first report created since you made the Test SNMP Interface
Targets Report template, that it is the Report Template already selected.
11
Since the monitor already filters devices, we add no filter in the Report, although you could
add one to further filter the target devices and/or subcomponents.
12
Test SNMP Interface Target Report should appear in the Reports portlet.
13
Right-click and select Execute (noticing that you can also schedule such reports, even
repeatedly).
14
Click the magnifying glass to the right of the Report Completed message in My Alerts to see
the report.
Monitor Options Type-Specific Panels
The following describes the panels associated with the following
Monitor Options
types.
•
Adaptive CLI
•
Cisco IPSLA
•
Cisco Metro Ethernet SLA Monitors
•
Cisco QoS Monitors
•
ICMP
•
Juniper CoS
•
Juniper RPM
•
Key Metrics
•
ProScan
•
SNMP
•
SNMP Interfaces
•
SNMP Table Monitor
•
VRF
Adaptive CLI
For this monitor, see How to
Create an Adaptive CLI Monitor
on page 390.