Users Guide

Monitoring Network Availability | Performance Monitoring
OMNM 6.5.3 User Guide 391
Show Command
For this example, use the Cisco show ip traffic command. Run the command so you can see
the data you want to extract. Here, we want to know the number of dropped packets due to
adjacency and no route issues. Here is some example output:
c1720-1.30#show ip traffic
IP statistics:
Rcvd: 2072045 total, 1995503 local destination
0 format errors, 0 checksum errors, 0 bad hop count
0 unknown protocol, 0 not a gateway
0 security failures, 0 bad options, 0 with options
Opts: 0 end, 0 nop, 0 basic security, 0 loose source route
0 timestamp, 0 extended security, 0 record route
0 stream ID, 0 strict source route, 0 alert, 0 cipso, 0 ump
0 other
Frags: 0 reassembled, 0 timeouts, 0 couldn't reassemble
0 fragmented, 0 couldn't fragment
Bcast: 1952255 received, 4 sent
Mcast: 0 received, 0 sent
Sent: 86915 generated, 0 forwarded
Drop: 18 encapsulation failed, 0 unresolved, 0 no adjacency
0 no route, 0 unicast RPF, 0 forced drop
This command has more output, our only concern is extracting the number of no routes and no
adjacencies in the first section, underlined, above.
Create ACLI
Create a show ACLI for the show ip traffic command. This ACLI executes the command
and it will extract the appropriate data using RegEx.
1 Create a new ACLI (or modify an existing)
Create an attribute in ACLI for each attribute that you want to monitor. The Date Type must
be Integer.