Users Guide

Resource Management Portlets and Editors | Resource Management
174 OMNM 6.5.3 User Guide
When authentications are unsuccessful, click the icons to their right to remove or edit them. You
can also click the wrench/screwdriver “fix it” icon in the
Discover column to open an editor where
you can revise the authentications for that device.
Create New lets you create new authentications, Choose Existing lets you select from existing
authentications,
Test Device lets you try out the authentications you have selected, and Close
closes this screen. Notice that you can configure new or existing authentications’ port, retry and
timeout settings before you click
Apply (or Cancel ) in the authentication editor that appears after
clicking the “Fix it” button.
Save preserves the profile. You can then right-click it to select Execute . If you select Execute from
the profile editor, OpenManage Network Manager does not save the profile to execute later.
Execute begins discovery, and the message traffic between OpenManage Network Manager and
the device appears on the
Results panel.
Results
This is a standard Audit Trail/Job Status window displaying the message traffic. See also Audit
Trail/Job Status
on page 151 for more about retrieving audit trail archives.
A message (
Discovery Profile Execute is complete ) appears in the Messages at the bottom left of the
status bar.
Click the X in the top right corner of the discovery profile editor to close it.