Users Guide

Supported Dell Equipment 60
delete the Dell Networking C- Series Devices group in the Managed Resource
Groups portlet, or edit the filter criteria to 'Model contains Force10 C OR Model
contains Dell Networking C'. (27371)
Issues Resolved
• Dell Networking FTOS S-Series filters pick up any device whose model name
contains “S.” Workaround: Use the new Dell Networking S group. (26445)
• The Interface availability report displays negative values when the device’s
availability is indeterminate. (25576)
• No warning/message appears when the license expires (19375)
• Upgraded openSSL to version 1.0.2c that fixes the vulnerability (heartbleed) issue.
(2643)
• Device status is flapping from Responding to Indeterminate randomly (18787)
• Network Topology Background Image is not saved as default. (17641)
• Network dashboard does not really provide useful data without displaying to
which device the interface belongs. Now you can hover the cursor over a label to
see the device name. (14531)
• The Hardware Change report may erroneously display devices that just had a
firmware upgrade or downgrade. (19358)
• Discovery—When specifying network addresses using the Subnet type, you must
specify the Network address at the beginning of the subnet since Dell
OpenManage Network Manager assumes it is the starting IP address for the range.
If you specify an address in the middle of the subnetwork then Dell OpenManage
Network Manager may discover devices outside of that subnetwork. This also
means that IP addresses in the network that precede the specified address are not
discovered. To avoid these issues, use the CIDR specification of the network to
discover rather that the subnet ID. (16803)
• If you de-select ping as part of a discovery profile, discovery fails to validate
authentications. (PV-18146)The latest F10 MIBs contain S4820T device in the
F10-Products-MIB, however, the F10-Products-MIB used most recently in Dell
OpenManage Network Manager does not contain this device, or Z9000, MXL,
IOA. (21029)
• Dell Networking FTOS S-Series filters pick up any device whose model name
contains “S.” Workaround: Use the new Dell Networking S group. (26445)
• The Dell Networking FTOS S50AC device appears as a Dell Networking FTOS
S50DC device (17890).
• The firmware report displays unnecessary entries showing firmware changes from
empty to a firmware number. (18719)
• For Dell Networking FTOS S50V devices Dell OpenManage Network Manager may
show total memory to be less than memory used. (18301)
• You must click the drop down combo box for adding a port to a VLAN or adding
an interface to port-channel twice to open the box. (19847)
• The Dell Networking FTOS device driver appears as Force 10 FTOS Service Pack 1
in the MIB Browser. (21028)