Users Guide

Features/Devices Supported in 6.0 Service Pack 1 30
• Discovery now automatically updates monitor targets by default. Web Service
discovery also does not require a discovery profile exist in OMNM before it can
trigger discovery. When none exists, web services create a default profile with the
supplied parameters.
If you have updated your system, you must add the Refresh Monitor Targets
action to any existing discovery profiles you have created before this is the
default behavior in upgraded discovery profiles. (24151, 24477)
• Device Support
- Brocade – See Supported Brocade/Brocade RX Equipment on page 47
- Cisco – See Supported Cisco Equipment on page 47
This comes with two types of drivers:
CATOS - supports switches that only support CATOS firmware.
IOS - supports routers or switches that support IOS firmware. It also provides
support for Switches that can run both IOS or CATOS firmware. When view-
ing the Driver information, model OID support will end in .catos or . ios if
the hardware supports both. Note: Although both may be supported by the
hardware, they may not be both supported by OMNM. (25258)
- Dell–See Supported Dell Equipment on page 50
- HP – See Supported HP Procurve Devices on page 62
- Juniper – See Supported Juniper Devices on page 63
To see supported device models and OS versions, look in the Manage > Show
Versions menu.
The following outlines various features included in this package:
Adaptive CLIs
Cisco—See Adaptive CLIs on page 31 and Cisco Compliance Actions on page 36
below.
Juniper—See Juniper JUNOS Adaptive CLIs on page 32 below.
HP Procurve—N/A
Brocade—N/A
Proscans
Cisco—See the Cisco Compliance Policies below.
Juniper—See Juniper Compliance Policies below.
HP Procurve—N/A
Brocade—N/A
Monitors
Juniper—RPM
Cisco—IPSLA