Users Guide

New Features/Devices Supported in 6.5 16
• Safari blocks any and all keyboard input for FlashPlayer applications. As a work
around, use Chrome. (29120)
• OMNM requires Flash player to be installed and enabled in order for all features
to work, including license importing, uploading of files, and topology views. You
will need to configure your browser to always activate Flash. For Chrome, go to
Settings > Advanced > Privacy and security > Content settings > Flash > Ask first >
turning off. For Firefox, it should display an option in the upper left that asks if
you want to enable Flash always or just this once. Select always enable. (29413)
• Uploading files into OMNM, such as XML and MIB files, is a two-step process.
Starting from the file upload popup dialog, the first step is to select a file from the
local file system and the second is to push the button to upload the file. There is
a known issue where sometimes after selecting a file, the upload button is still
disabled. This issue is caused by a bug within the Flash plugin. If this does happen
then you will need to select the file again and then the upload button should be
enabled and you can complete the upload process by clicking this button.
(29413)
• Do no use IE on Windows 2016 server because it does not support flash. (29829)
• When upgrading to OMNM 6.5 the default schedule item for processing Change
Determination is replaced. As a result the scheduled execution time and enabled
state may need to be reconfigured to retain the previous behavior. (29620)
• When configuring ports and interfaces of Juniper devices that utilize jflow
version 9, the current assumption is that the target ports either already have an
inet address configured or is assigned an inet address by dhcp. (30132)
• End user receives a
Cannot find CLI Authentication message during the
SNMP trap configuration. This message is inaccurate, it should read “SNMPv3 is
not supported for trap configuration.” (29990)
• Executing remove configuration against a Juniper device with only one flow-
server will result in an error being thrown due to the inline-jflow configuration
requiring at least one flow-server. Removing the last flow-server will require the
user to either directly access the device for manual configuration or to create an
Action that executes the required commands to remove both the flow-server and
the inline-jflow. (30111)
• Configuring the Flow-samplers for Cisco IOS Devices can be done using the
following Actions: Cisco Device Configure Flow-Sampler and Cisco Device
Remove Flow-Sampler for device level configuration, Cisco Port Configure Flow-
Sampler and Cisco Port Remove Flow-Sampler for port level configuration.
(30185)
• Fans and power supply are now being discovered for Dell EMC Networking
devices and Dell EMC Networking FTOS devices. (36464)
• For OMNM 6.5 linux installation, internet access is required to do an upgrade to
6.5. A yum command (yum -y install libaio) is required during the install process.
If internet access is not available for the OMNM server, the libaio package needs
to be manually installed prior to installation. (28065)