Owners Manual

Actions Portlet | Actions and Adaptive CLI
OMNM 6.5.2 User Guide 563
Adaptive CLI Editor
This editor creates new Adaptive CLIs When you click New, or Edit after, selecting an existing
command, the command editor screen opens. You can create
Configure Command s, External
Command
s, and Show Command s.
The editor screen has the following tabs (the ones that appear depend on the type of command you
are editing):
•
General
• Attributes
• Scripts
The Adaptive CLI Manager logs into devices in enable mode by default. For most configuration
commands (and even some show commands), you must typically first set the device to its
configuration mode. For example: The first Adaptive CLI Manager command must be
config t
(Juniper E-Series) or
edit (Juniper M/T series) to initiate the router's config/edit mode.
OpenManage Network Manager also validates entries. If saving fails, a red “X” appears next to
required omitted entries.
Click
Save to preserve the Adaptive CLI you have configured. Clicking Close does not save your
configuration.
General
The following are parameters to configure in this panel:
Name —A unique identifier for this action. For example: “Retrieve MyDevice MAC addresses.”
For a new action to appear on the right-click Action menu, begin its name with the vendor
name. For example,
Force10-showversion would appear under Actions in that menu.
Otherwise, it appears under and Adaptive CLI classification.
Description —A text description of the action.