Owners Manual

Monitoring Network Availability | Performance Monitoring
OMNM 6.5.2 User Guide 403
Qos Actions
—These include: Queueing, Random Detect (WRED), Traffic Shaping, Police, Set
(Packet Marking), Compression (IP header), Account (C3pl).
See
Additional QoS Monitors on page 403 for attributes you can monitor related to
these.
Monitor Entitles
Select the equipment to monitor in this screen. Notice the PF and IF columns that indicate
whether a port filter or interface filter is active to further limit what parts of the selected device is
monitored. Delete the device or configure port and interface filters with the icons to the right of
listed equipment.
QOS Properties - Monitored Attributes
This panel lets you select attributes monitored with right/left selection arrows. Move the desired
attributes from the
Available to the Selected side of this panel. Notice that, by default, you can
monitor two additional calculated attributes. You can also edit the monitor to create additional
calculated attributes, which would also appear here.
NOTE:
If you change the bandwidth (speed) on an port/interface, you must resync the device to update the port
speed in OpenManage Network Manager. You must refresh targets on any QOS monitor after resync for
the application to reflect the correct MaxClassBandwidth value. See also Bandwidth Calculation on page
418.
Additional QoS Monitors
The sections below list the monitored attributes for possible Monitor types that include the
following:
•
Qos Class Map Monitor
• Qos Match Statement Monitor
• Qos Police Monitor
• Qos Queuing Monitor
• Qos Traffic Shaping Monitor
• Qos RED Monitor
• Qos IPHC Monitor
• Qos Packet Marking Monitor
• QoS Police Monitor
• Qos Estimate Bandwidth Monitor
• QoS C3pl Account Monitor
Qos Class Map Monitor
Qos Class Map Monitor collects metrics from the cbQosCMStatsTable. This table specifies
ClassMap related Statistical information.
Available Metrics:
DropBitRate
PrePolicyPkt
PrePolicyByte
PrePolicyBitRate
PostPolicyByte
PostPolicyBitRate