Owners Manual

Table Of Contents
Supported HP Procurve Devices
60
At Port Level: FCReadBytesRate, FCReadRate, FCWriteBytesRate, FCWriteRate,
ISCSIReadBytesRate, ISCSIRead, ISCSIWriteBytesRate, ISCSIWriteRate,
PacketsNetworkIn, PacketsNetworkOut, OctetsIn, OctetsOut.
At the LUN/Disk level: LUNAverageRead, LUNAverageWrite,
LUNAverageQueueLength, LunReadBytesRate, LUNReadRate, LUNResponseTime,
LUNTotalCall, LUNWritten, LUNWrite.
Known Issues
No known issues at this time.
Supported HP Procurve Devices
The following describes supported HP Procurve devices and their known issues.
Support added for STFP. (24683)
Supported devices include the following:
A6713A, A6716A, A6717A, J3177A, J3299A, J4110A, J3100A, J3175A, J3245A,
J3298A, J4120A, J4121A, J4122A, J4122B, J4138A, J4139A, J4812A, J4813A,
J4819A, J4840A, J4841A, J4860A, J4865A, J4874A, J4887A, J4899A, J4899B,
J4899C, J4900A, J4900B, J4900C, J4902A, J4903A, J4904A, J4905A, J4906A,
J8130A, J8133A, J8153A, J8154A, J8155A, J8164A, J8165A, J8433A, J8474A,
J8680A, J8692A, J8693A, J8697A, J8698A, J8718A, J8719A, J8752A, J8753A,
J8762A, J8770A, J8771A, J8772A, J8773A, J8992A, J9019A, J9019B, J9020A,
J9021A, J9022A, J9028A, J9029A, J9031A, J9032A, J9038A, J9049A, J9050A,
J9085A, J9086A, J9088A, J9089A, J9091A, J9138A, J9145A, J9279A, J9280A,
J9299A, J9310A, J9311A, J9470A, J9471A, J9477A, J9623A, J9624A, J9625A,
J9626A, J9627A, J9727A, J9729A, J9772A, J9773A, J9774A, J9775A, J9776A,
J9778A, J9781A, J9782A, Proliant Series Switches.
Supported features include the following: Discovery SNMPv1, SNMPv2, SNMPv3,
Telnet, SSHv2, HTTP; Deep Discovery; Link Discovery; Configuration File Backup,
Restore, Deploy; Proscan, Change Management; Action/Adaptive CLI; Direct
Access; Event Management; Fault Management, Performance Monitors (ICMP,
SNMP Interface, SNMP); Reports; Network Views.
Known Issues
OMNM may not always detect telnet disconnects sent by a device. A timeout may
indicate a false failure for the telnet session when it is actually successful. This
means the system may be unable to detect a disconnect has occurred between
itself and a device when a device reboot accompanies restore or deploy actions.
(4296, 2338, 4323)
Due to limitation of the switch, we are not supporting temperature. (27574)