Owners Manual

Table Of Contents
Supported Brocade/Brocade RX Equipment
45
Known Issues
OMNM does not support telnet for alcatel devices. The alternative is to use SSH.
(28836)
Supported Brocade/Brocade RX Equipment
The following describes supported Brocade equipment and its known issues.
Supported devices include the following: 6510, AP7600, Connectrix ED-480000B,
DCX4S, Silkworm 2800, Silkworm 4100, B-DC 4XS and B-80, B-MLXe4, B-
MLXe8, B-MLXe16, B-FCOE1024, B-FCX624, B-FCX624S, B-FCX648, B-FCX648S,
B-TI24X, B-RX4, B-RX8, B-RX16, B-8000/8000e, B-DCX4S, M8428k.
Supportded firmware versions: 5.2.0 or higher.
Supported features include the following: Discovery SNMPv1, SNMPv2, SNMPv3,
Telnet, SSHv2; Deep Discovery; Configuration File Backup, Restore; Proscan,
Change Management; Action/Adaptive CLI; Direct Access; Event Management;
Fault Management, Performance Monitors (ICMP, SNMP Interface, SNMP);
Reports; Network Views.
Known Issues
If you upgrade to OMNM, fabric information does not appear for some devices.
Workaround: Delete and rediscover the device after upgrading. (25280)
OMNM does not discover the management port on Brocade devices. (25024)
Ports are listed in Brocade’s MIBs as ethernet, so OMNM always discovers them as
ethernet. (24982)
M8428K does not display performance indicators in the details panel. (17447)
A limited amount of interface data is collected from Brocade Ethernet capable
switches. As a result, interface reports and the Interfaces portlet do not contain
Ethernet Link data.(18800, 18802)
Right-click menu in Performance - Top Ping Response portlet does not appear.
Workaround: Right-click in the Managed Resources portlet. (18827)
OMNM will not telnet connect to some devices if they use the factory default
password. You must set the password to something other than that default.
OMNM does not recognize the additional prompt asking that default password
be changed each time log in occurs. (12240)
Supported Cisco Equipment
The following describes supported Cisco equipment and its known issues.
Driver support added for Cisco 2960X-24TS-L. (32118)
The following monitors were added: Cisco Ethernet SLA, Cisco IP SLA, Cisco
QOS. (28136)
Driver support added for Cisco SFP DOM pluggable transceiver components,
including Key Metrics monitoring. (24640)
Driver support added for Cisco ASR 1000 series devices running IOS XE v. 15.x.
Devices supported: ASR 1001,1002, ASR 1002F, ASR 1004, ASR 1006, ASR 1013,
CSR 1000V (Virtual Emulator). (19509)