Owner's Manual

Security 85
capability to control access to cut-thru session capabilities (read vs. read-write) when a
command line interface is present to the managed device.
NOTE:
Resync fails if you do not check this box.
Select HTTP/HTTPS Parameters
- UserID —The login ID.
-
Confirm Password — Confirm the password.
Confirm your entries here with
File -> Save or by clicking on the Save icon or button.
SNMP v1/v2
Enter information for v1 or v2 SNMP authenticators through the General (SNMP) page, shown
below. Some fields — Read Community, Write Community, and Trap Community—pre-fill with
default values.
Figure 4-13. Authenticator Editor — General (SNMP) Page
The following are the fields in the General (SNMP) page:
General Parameters
- ID — (Required) This entry must be unique; it identifies the authentication object.
-
Use for EMS —Checking this lets this application—the entire element management system
(EMS)—use this authentication. Otherwise, authentications are only available to individual
users who have permissions to use them.
If none of the associated credentials are marked
Use for EMS then the software chooses the
set of authentications to which the current user has access. Administrators typically use this