Owner's Manual

Events, Rules and Actions 841
Basic Variables
The following section describe variables whose use may have a performance impact.
Managed Equipment Variables
Attribute Description Email Action Variable
Name The event / alarm name {Name}
Message Description from the event {Message}
Entity Name The entity (interface, card...) name {EntityName}
Equipment Manager
Name
The name of the equipment, parent or chassis. {EquipMgrName}
Device IP address the IP of the device in alarm {DeviceIP}
Entity Type Type of entity (Router, and so on) {EntityType}
Instance ID An identifier for the event {InstanceID}
Protocol Type Of originating alarm (SNMP, syslog, etc.) {ProtocolType}
Protocol Sub Type Inform, Trap, [blank] (for internal events) {ProtocolSubType}
Receive Time {RecvTime}
Region The mediation server partition name. {Region}
Severity 0 - cleared, through 6 - critical, from Alarm
Definition
{Severity}
Source IP address The IP of the component sending the alarm {SourceIP}
Attribute Description Email Action Variable
Custom 1 Note that although you can
re-name any Custom
attribute, you must use the
variable’s original name.
For example here, that is
{RedCell.Config.Equipme
ntManager_Custom1}
{RedCell.Config.EquipmentManager_Cust
om1}
Custom 2 {RedCell.Config.EquipmentManager_Cust
om2}
Custom 3 {RedCell.Config.EquipmentManager_Cust
om3}
Custom 4 {RedCell.Config.EquipmentManager_Cust
om4}
Custom 5 {RedCell.Config.EquipmentManager_Cust
om5}
Custom 6 {RedCell.Config.EquipmentManager_Cust
om6}