Owner's Manual

Events, Rules and Actions 837
Execute Command—Specify the command executable with the command button (...). It
opens a selection screen.
Forward Northbound as SNMP v2—Specify the destination address, port and SNMP com-
munity string, and check if you want the notification sent as proxy. See Trap Forwarding
Process on page 846 for details.
NOTE:
To enable trap forwarding, first specify 162 as the port. You must also edit /opt/dorado/
owareapps/redcell/lib/redcell.properties.
Do a search for category that will
take you to the right section in the property file. Here is the important section whose last line you must
change:
##This property should be used for linking job with assure. This property
##defines list of jobs for which alarm notification is generated in the
alarm window.
##The property should be defined in the format <jobcategory>:<notification
type>
##Valid Notification types are 0 - Job success, 1 - Job failure, 2 - Notify
Success or Failure, 3 - No Notification
append.oware.job.alarm.notification.list=EQUIPMENT.RESYNC:1,com.dorado.red
cell.service:2
The added phrase is this: com.dorado.redcell.service:2
Change Manager
Common Services
Email—Specify a destination address, then click Add. You can specify more than one, and
specify a header/footer and e-mail message to be triggered by correlation. See Email
Options for additional information about customizing the messages sent. See Email
Variables from Alarms on page 839 for a description of the available variables them-
selves.
CAUTION:
Because equipment can frequently generate literally thousands of traps, configure this action with care,
limiting e-mails sent to only those events that are significant. Otherwise, performance, and your mail
recipients, suffer.
Equipment Discovery—Specify the discovery profile to execute.
Equipment Resync—This triggers a resync of all equipment.
File Management
Backup Config—This triggers a backup of the equipment’s configuration.
Restore Configuration—Restore the equipment’s configuration to the selected label.
Service Center MPLS
Update LSP Status—This triggers an update of the LSP’s status.