Owner's Manual

760 Active Performance Monitor
3 In the General screen, enter a name (here “TestMonitor”), check Enabled , enter a polling
interval (here 1 minute, the default). For this example, check
Retain polled data and accept
the remaining defaults for checkboxes and the retention policy.
You can accept the default
SNMP Attributes , or alter them to include fewer or more
attributes (click
Add or Remove next to the attributes). For the sake of this example, we
accept the default list of attributes to monitor.
4 Select the interfaces you want to monitor by clicking Add in the top right corner of the screen.
A selection screen appears, when you do. You must typically select a device in the upper panel,
then select at least one an interface in the lower one. You can multi-select by left-clicking
while holding down the Ctrl key. You can also click
Add Group if you have previously created a
group.