Owner's Manual

684 Topology Views
Printing Topology Views
If you print a topology, a configuration dialog appears with four tabs.
Figure 21-21. Print Dialog–Paper Tab
Paper
The Paper tab has the following fields:
-
Paper Format —Select from the pick list ( A3, A4, A5, US Executive, US Letter, US Legal, and
Custom ). The current default is A4 (and measurements default to cm ).
-
Paper width / height —A pair of read-only fields, unless you select Custom in the pick list above
them.
NOTE:
Set the units for this display at the bottom of the Print dialog.
Bottom / Top / Left / Right Margin —Set the margins in these fields.
Orientation —Click on the icons to select
Click
Apply to execute any edits on this print job, click Default on this tab to return to the tab’s
defaults. Click
Default at the bottom of the screen to reset all tabs’ defaults. Click Print to print
the screen, or
Close to abandon the print job and close this screen.