Owner's Manual

624
See Adjusting Time-outs on page 625 for changes you can make to device response time-out
problems.
J-series Deploy
This vendor panel appears when you deploy to a J-series (M/T/J) device.
Figure 13-2. J-series Deploy
This screen has the following fields:
-
File Path —Pre-populated with /var/tmp/ (where most J-series devices suggest you place the
package for upgrade). You can specify a different path to place the package for upgrade. Best
practice is to use
/var/tmp/.
- Install to Backup RE —Installs the package on the backup routing engine. This is valid only for
devices that support dual routing engines.
-
Request Force Add —Forces the addition of a package (ignores warnings).
-
Va li da t e —Checks compatibility with current configuration.
-
Cleanup —Deletes the downloaded image from the router after deploy.
-
Delay Restart —Processes will not restart on router.
-
Request System Reboot —Reboots the router after upgrade. Discards the configuration on the
device, replacing it with the selected configuration file.
NOTE:
Below this screen, a reminder appears to reboot the device to take full advantage of any new features
exposed by the deployment.
See Adjusting Time-outs for changes you can make to device response time-out problems.