Owner's Manual

608
Figure 13-156. Unit Services Configuration
You can configure the following:
Input Parameters
- Input Service-Set (1,2,3) —Select from the pick list.
-
Filter —Select from the pick list for the selected input service.
-
Post-Service-Set —Select from the pick list.
Output Parameters
- Output Service-Set (1,2,3) —Select from the pick list.
-
Filter —Select from the pick list to filter the selected service.
General Parameters
- Service Domain —Service-domain specifies whether the interface is used within the network or
to communicate with remote devices.
Optionally include filters before or after each service set to refine the target and additionally
process the traffic.
Service Options
This configures a port’s ability to use syslog and other options.