Owner's Manual

599
atm-tcc-vc-mux—ATM VC for translational cross-connect.
atm-vc-mux—ATM VC multiplexing.
ether-over-atm-llc—Ethernet over ATM (LLC/SNAP) encapsulation.
ether-vpls-over-atm-llc—Ethernet VPLS over ATM (bridging) encapsulation.
dix—Ethernet DIXv2 (RFC 894).
vlan-ccc—802.1Q tagging for a cross-connect.
vlan-vpls—VLAN Virtual Private LAN Service (VPLS).
frame-relay—Frame Relay DLCI.
frame-relay-ccc—Frame Relay DLCI for CCC.
frame-relay-tcc—Frame Relay DLCI for translational cross-connect.
multilink-frame-relay-end-to-end—Multilink Frame Relay end-to-end (FRF.15).
multilink-ppp —Multilink PPP.
- Status —Enable/Disable this logical interface.
-
Description —Text description of the interface.
-
DLCI —Frame Relay link control identifier (1 - 1022). Appears only for Sonet ports.
-
VLAN ID —Virtual LAN identifier value for 802.1Q VLAN tags (0 - 4094). Appears only for
ethernet or lt ports.
-
VPI —Allow all VCIs in this VPI to open in atm-ccc-cell-relay mode (0 - 255). Appears only for
ATM ports.
-
VCI —ATM point-to-point virtual circuit identifier. Appears only for ATM ports.
-
Active —Check to activate this unit.
-
Enable Inverse ARP —Enable/Disable Inverse ARP.
-
Traps —Enable SNMP notifications on state changes.
-
Passive Monitor Mode —Use interface to tap packets from another router.
-
Multipoint —Multipoint connection.
-
Point to point —Point-to-point connection.
-
Allow any VCI —Allow any ATM point-to-point virtual circuit identifier.
-
Peer Unit —Enter an identifier for a peer unit. Appears only for lt ports.
The sections below describe Unit configuration
Family options. These tabs appear enabled
depending on the type of interface you select:
Inet
This screen configures Inet parameters.