Owner's Manual

595
cbr—Constant bandwidth utilization.
rtvbr—ATM2 real-time variable bandwidth utilization.
vbr—Variable bandwidth utilization.
- Constant Bandwidth —(For shaping type cbr only) Constant bandwidth utilization ( 33,000 -
542,526,792
).
Burst size —For shaping type vbr and rtvbr, ( 1 - 4,000 ).
Peak rate —For shaping type vbr and rtvbr, ( 33,000 - 542,526,792 ).
Sustained rate —For shaping type vbr and rtvbr ( 33,000 - 542,526,792 ).
Click
Apply to accept the edits you make on this screen, and Cancel to abandon them.
Unit Configuration
Unit configuration screens include an upper screen (for General configuration) that varies,
depending on the unit type and encapsulation selected, and a lower screen with tabs that are
enabled/disabled, depending on the upper screen.
In all cases, click the
Configure button at the bottom of the screen to send your edits to the
selected equipment and
Refresh to update the current screen.
The following sections describe these lower,
Family screens:
• Inet on page 599
• Iso - OSI ISO protocol on page 601
• inet6 - IPv6 protocol on page 601
• Mpls - Multiprotocol Label Switching on page 602
• Mlppp - Multilink PPP protocol parameters on page 603
• mlfr-e2e - Multilink Frame Relay end-to-end on page 603
• mlfr-uni-nni - Multilink Frame Relay UNI NNI on page 603
• Ccc - Circuit Cross-Connect on page 604
• Tcc - Translational Cross-Connect on page 604
• Vpls - Virtual Private LAN Service on page 605
• Tunnel Configuration / GRE Unit Tunnel on page 606
• Shaping on page 606
• Unit Services on page 607
• Service Options on page 608
General Unit configuration options include the following screens. See Policy Options -> Firewall
Filters on page 468 and Policy Options -> Policers on page 467 for information about how to
configure filters and policers. Not all options are enabled for all equipment.