Owner's Manual

588

DS0

This screen lets you configure DS0 options.

Figure 13-135. Interface—DS0

BERT Algorithm

—Set BERT algorithm.

BERT Error Rate

—Bit error rate to use in BERT test (10^-n) (0 - 7).

BERT Period

—Length of BERT test (1 - 240 seconds).

Frame Checksum

—Frame checksum;

32-bit mode

Byte Encoding

—Byte encoding;

8 bits per byte

Idle Cycle Flag

—Value to transmit in idle cycles;

0x7E

0xFF

Invert Data

—Invert data.

Loopback Mode

—Loopback mode; Default or Payload.

Start/End Flag

—Set start/end flags on transmission.

filler—Send two idle cycles between start/end flags

shared—Share start/end flags on transmit

This screen lets you configure T1 options.