Owner's Manual

583
- RFC 2615 —RFC 2615 compliance
-
Z0 Increment —Increment Z0 in SDH mode
Auto Protection Switching Options
- Advertise Interval —Advertise interval (milliseconds)
-
Hold Time —Hold time (milliseconds)
-
Revert Time —Circuit revert time (seconds)
-
Neighbor Address —IP Address of Neighbor
-
Paired Group —Name of paired APS group
-
Authentication Key —Authentication key
-
Circuit Group —Working or Protected circuit group name, based on state.
-
Circuit State —Request/Force circuit state. This lets you select from the following options:
default—System default
lockout—Lockout protection
request-working—Request working circuit state
request-protect—Request protect circuit state
force-working—Force working circuit state
force- protect—Force protect circuit state
Sonet Header Bytes Options
- E1 Quiet —E1-quiet value (0 - 255)
-
S1 —S1/Z1 value (stratum clock by convention) (0 - 255)
-
F1 —F1 user value (0 - 255)
-
F2 —F2 user value (0 - 255)
-
Z3 —Z3 user value (0 - 255)
-
Z4 —Z4 user value (0 - 255)
PPP
This screen lets you configure the ppp chap parameters.