Owner's Manual

547
- SPF Delay —Configure the shortest path first (SPF) delay. The field lets you specify the number
of milliseconds between the detection of a topology change and when the SPF algorithm
runs. Range: 50 through 1000 milliseconds Default: 200 milliseconds
-
Domain ID —Specify a domain ID for a route. The domain ID identifies the OSPFv2 domain
from which the route originated. Default: If the router ID is not configured in the routing
instance, the router ID is derived from an interface address belonging to the routing instance.
-
Disable Domain ID —Disable domain ID. If this is selected, a Domain ID value cannot be
entered in the previous field.
-
Domain VPN Tag —Set a virtual private network (VPN) tag for OSPFv2 external routes
generated by the provider edge (PE) router.
Trace Options
- File Name —The filename that receives the output of the tracing operation. All files are in the
directory
/var/log . Best practice typically is to put OSPF tracing output in the file ospf-
log
.
-
File Size —Maximum size of each trace file, in kilobytes (KB). When a trace file (for example,
kmd ) reaches this size, it is renamed, kmd.0 , then kmd.1 and so on, until the maximum
number of trace files is reached—then device overwrites the oldest trace file. Default: 1024
KB
-
File Count —The maximum number of trace files. When a trace file (for example, kmd ) reaches
this size, it is renamed,
kmd.0 , then kmd.1 and so on, until the maximum number of trace
files is reached—then device overwrites the oldest trace file. If you specify a maximum
number of files, you must also specify a maximum file size with the size option. Range: 2
through 1000 files Default: 10 files.
Flags
The following checkboxes set flags:
-
Event —OSPF and OSPFv3 state transitions.
-
State Detail —Provide detailed trace information for State transitions.
-
Error Detail —Provide detailed trace information for OSPF and OSPFv3 error packets.
-
Settings Type —Select Export Policies, Area or Interface. The remaining screen’s appearance
depends on your selection here.
Export Policies
Apply one or more export policies to routes being exported from the routing table into OSPF by
using the arrows to move policies from
Available to Selected. Notice that you can also use the up/
down arrows below those
Selected to re-order the list of policies in force.