Owner's Manual

546
metric—Primary metric on all routes sent to peers. Range: 0 through 4,294,967,295 (232 -1)
Default: No metric is sent.
minimum-igp—Set the metric to the minimum metric value calculated in the IGP to get to
the BGP next hop. If a newly calculated metric is greater than the minimum metric
value, the metric value remains unchanged. If a newly calculated metric is lower, the
metric value is lowered to that value.
offset—(Optional) Increases or decreases the metric by this value. Range: -231 through 231
-1 (No default).
- Neighbors —Explicitly configure a neighbor (peer). To configure multiple BGP peers, include
multiple neighbor statements. Specify an IPv6 or IPv4 address for each peer.
-
Export Policies —Click the arrows to move Available to Selected policies (or vice-versa). Apply
one or more policies to routes being exported from the routing table into BGP. Noticed that
you can also re-order policies with the up/down arrows below the
Selected panel.
OSPF (and OSPF3)
OSPF & OSPF3 settings have identical forms.
Figure 13-101. Routing Instances -> VRF Instances - OSPF and OSPF3 (Export policies)
The following attribute descriptions apply to both tabs