Owner's Manual

535
Discard Packets—Drop packets to destination; send no ICMP unreachables.
Receive Packets—Install a receive route for the destination
- Ty p e — Select from the pick list:
Default - Do not configure.
Active—Remove inactive route from forwarding table.
Passive —Retain inactive route in forwarding table.
You can specify up to four metric values, starting with metric (for the first metric value) and
continuing with metric2, metric3, and metric4. You also can specify a secondary preference value
(preference2).
Metric —Enter an LSP metric value (1 - 65,535).
Preference —Enter an LSP preference value (1 - 255).
- The following are the
Next Hop checkboxes:
-
Retain —Always keep route in forwarding table.
-
Install —Install route into forwarding table.
-
Readvertise —Mark route as eligible to be readvertised.
-
Resolve —Allow resolution of indirectly connected next hops.
Next Hop
You can only configure the Next Hop List, LSP Next Hop list and the P2MP Next Hop when you
select
Forward Packets as the Action. Add the address entered below the list, or Delete a selected
entry to manage the next hop list. The application will inform you with an error message if you try
to configure with a different action.
LSP Next Hop
In this tab you can configure LSP next hops. You can configure multiple LSP next hops using the
list manager. Add a new entry or Edit an existing entry in the list. Click Apply to apply the LSP
attributes for that entry in the LSP Next Hop list.