Owner's Manual

531
- Virtual Addresses —When you are configuring VRRP on Fast Ethernet and Gigabit Ethernet
interfaces only, configure the addresses of the virtual routers in a VRRP group. You can
configure up to eight addresses. Addresses of one or more virtual routers. Do not include a
prefix length. If the address is the same as the interface's physical address, the interface
becomes the master virtual router for the group.
-
Track Interfaces —On Fast Ethernet and Gigabit Ethernet interfaces only, enable logical
interface tracking for a VRRP group. Up to 10 interfaces can be tracked. For each tracked
interface, you must configure a Priority Cost.
NOTE:
When they are available, you can now select IRB ports in this screen. See Integrated Bridging -> Bridge
Domain on page 573 for more.
- Priority Cost —The value subtracted from the configured VRRP priority when the tracked
interface is down, forcing a new master router election. The sum of all the costs for all
interfaces or routes that are tracked must be less than or equal to the configured priority of
the VRRP group. (1 - 254).
The
Configure button at the bottom of this screen sends the selected configuration to the device.
The
Refresh button queries to update information displayed.
Routing Options -> General
This screen manages general routing options.
Figure 13-88. Routing Options -> General -> Route Options
It contains the following tabs:
• Route Options
• Autonomous
• Confederation
•Maximum Routes