Owner's Manual

516
Figure 13-74. Routing Protocols: OSPF Peer Interface
Click Add (or select an interface listed on the left and click Edit ) to open the editor in the right
panel. Select an interface and click
Delete to remove it from the list. Click Apply to accept your
edits;
Cancel abandons them. Configure the following with this tab:
-
Name —Use the pick lists to locate an available interface.
-
Disable —Check to disable OSPF on this interface.
-
Dead Interval —1 - 65535 seconds. This specifies how long OSPF waits before declaring that a
neighboring router is unavailable. This is an interval during which the router receives no hello
packets from the neighbor.
-
Hello Interval —1 - 255 seconds. This specifies how often the router sends hello packets out the
interface. The hello interval must be the same for all routers on a shared logical IP network.
-
Retransmit Interval —1 - 65535 seconds. This specifies how long the router waits to receive a
link-state acknowledgment packet before retransmitting link-state advertisements to
an interface's neighbors.
-
Transit Delay —1 - 65535 seconds. This sets the estimated time required to transmit a link-state
update on the interface. When calculating this time, you should account for transmission and
propagation delays.
The
Configure button at the bottom of this screen sends the selected configuration to the device.
The
Refresh button queries to update information displayed.
Protocols -> ISIS Interfaces
This screen manages ISIS Interface settings.