Owner's Manual

515
Figure 13-73. Routing Protocols: OSPF Stub/NSSA
Configure the following with this tab:
-
Ty p e —Select from the pick list:
Stub - Configure a stub area
NSSA - Configure a not-so-stubby area
- Summaries / No-Summaries —Check to activate. (These are mutually exclusive, but you can also
activate neither). Summaries flood summary LSAs into this stub/nssa area.
-
Default Lsa —Check to activate.
-
Ty p e - 7 —Flood type 7 default LSA if no-summaries is configured. Check to activate.
-
Area Range —Configure NSSA area ranges. Enter a range below the list panel, then click Add
(click Edit to alter a selected range, or Delete to remove it) .
- Metric Type —External metric type for the default type 7 LSA (1 - 2). Select from the pick list.
-
Default Metric —Metric for the default route in this stub/nssa area (1 - 16777215). Enter a
default in the field.
Peer Interface
This tab lets you configure peer interfaces for the selected OSPF interface.