Owner's Manual

498
- Enable IPv6 Tunneling —Allow IPv6 routes to be resolved over an MPLS network by converting
all routes stored in the inet.3 routing table to IPv4-compatible IPv6 addresses and then
copying them into the inet6.3 routing table. This routing table can be used to resolve next
hops for inet6 and inet6-vpn routes.
-
Don’t Record Transit Routers —Check to enable.
-
Run Aggressive Optimization —If enabled, the LSP reoptimization is based solely on the IGP
metric. The reoptimization process ignores the available bandwidth ratio calculations, the
least-fill 10 percent congestion improvement rule, and the hop-counts rule. This statement
makes reoptimization more aggressive than the default.
Auto Policing
This tab lets you pick auto-policing options.
Figure 13-58. Protocols -> Setup:MPLS (Auto Policing)
Here, you can select policing options for MPLS for all classes ( Class All ) or for individual classes
(
Class ct0, Class ct1, Class ct2, Class ct3 ). You can specify the following policer actions by
selecting them from the pick list:
-
Default —no action
-
Drop Packets —Drop all packets.
-
Set Loss Priority to High —Set the packet loss priority (PLP) to high.
-
Set Loss Priority to Low —Set the packet loss priority (PLP) to low.
RSVP
This tab manages RSVP.