Owner's Manual

496
You are not required to configure the traffic engineering classes. The following table shows the
default values for everything in the traffic engineering class matrix. The default mapping is
expressed in terms of the default forwarding classes defined in the CoS configuration.
Log Up-Down
This tab manages SNMP and Syslog messaging for MPLS.
Figure 13-55. Protocols -> Setup:MPLS (Log Up-Down)
These log a message or send a Simple Network Management Protocol (SNMP) trap whenever an
LSP makes a transition from up to down, or vice versa, and whenever an LSP switches from one
active path to another. Only the ingress router performs these operations. This tab has the
following checkbox pairs:
• Send/Don’t send Syslog Messages
• Send/Don’t send SNMP traps
• Send SNMP Traps When a Path goes up/down.
Bandwidth
This screen lets you set MPLS bandwidth two ways.
Traffic
Engineering
Class
Class
Type
Queue Priority
te0 ct0 0 7
te1 ct1 1 7
te2 ct2 2 7
te3 ct3 3 7
te4 ct0 0 0
te5 ct1 1 0
te6 ct2 2 0
te7 ct3 3 0